Product Features :

Termite control- Methods of application and equipment for use: 1. During construction: Mix 1 Ltr. of Saiban 50% EC with 99 L of water to get a 0.5% Saiban emulsion and apply at the following stages. Satge 1 - Treat the bottom surface and sides (upto 30cm. Height) of the excavations made for column pits, wall trenches and basements @ 5L per sq. m of surface area, Stage 2 - Treat the refill, Earth on both sides of all built up walls (approximately width 30cm and depth 45cm) @ 7.5 per sq.m of substructure, Stage 3 - Treat the entire leveled surface (before laying the floor) @ 5L per sq.m In case of RCC framed structures with columns and plinth beams and RC basements, the treatment can start at a depth of 50cm, below ground level. Wherever pipes, wastes and conduits enter soil, loosen the soil for a distance of 15cm. And 7.5cm deep and thoroughly drench with Saiban 50% EC emulsion. Note: AII applications should be done when the surface is dry to facilitate better absorption. Treatment of existing build i) Dig shovel width trenches along the external wall of the building exposing the foundation wall surfaces up to a depth of 50 cm. and made 30 cm-50cm, deep rod holes. 15 cm apart all along this trench and pour Saiban 50% Ec emulsion@1.75 litrs per running meter, ii) treat the back fill each with earth Saiban 50% emulsion @0.5 L per running meter as it is returned to the trench directing the spray towards the wall surface. PS- If the concrete or masonry apron around the building, drill 12mm holes as close as possible to the plinth wall 30 cm apart and pump insecticide A) RCC framed Structures: Excavate shovel width trenches exposing the sides of the column and plinth beams up to 30 cm(or bottom of the plinth beams) and treat the back fill earth with Saiban 50% emulsion as it is returned to the trench, @ 7.5 L per sq.m of the vertical Surface of the structure, B) Internal treatment (Soil under floors): Soil below any openings of the floor is to be charged with the chemical so as to deny access to termites. 1. Drill 12 mm holes at the junction of floor and walls along the cracks on the floor and along constructional joints at 30 cm. Intervals to reach the soil below. Squirt the emulsion @ 1 L per hole or till refusal and seal the holes in the masonry wall at about 45% angle preferably from both sides of the plinth wall at 30 cm. Interval and soak the masonry Saiban 50% EC properly as above. Upper Floors:- Termites damages upper floors, flats passing through casings of telephone pipe, woods on walls stair cases, false ceiling etc.. To prevent damage treat ground floor of existing building as in above section.